A GDB command is a single line of input. There is no limit on
how long it can be. It starts with a command name, which is followed by
arguments whose meaning depends on the command name. For example, the
command step accepts an argument which is the number of times to
step, as in `step 5'. You can also use the step command
with no arguments. Some command names do not allow any arguments.
GDB command names may always be truncated if that abbreviation is
unambiguous. Other possible command abbreviations are listed in the
documentation for individual commands. In some cases, even ambiguous
abbreviations are allowed; for example, s is specially defined as
equivalent to step even though there are other commands whose
names start with s. You can test abbreviations by using them as
arguments to the help command.
A blank line as input to GDB (typing just RET) means to
repeat the previous command. Certain commands (for example, run)
will not repeat this way; these are commands whose unintentional
repetition might cause trouble and which you are unlikely to want to
repeat.
The list and x commands, when you repeat them with
RET, construct new arguments rather than repeating
exactly as typed. This permits easy scanning of source or memory.
GDB can also use RET in another way: to partition lengthy
output, in a way similar to the common utility more
(see section Screen size). Since it is easy to press one
RET too many in this situation, GDB disables command
repetition after any command that generates this sort of display.
Any text from a # to the end of the line is a comment; it does nothing. This is useful mainly in command files (see section Command files).
Go to the first, previous, next, last section, table of contents.