Go to the first, previous, next, last section, table of contents.
GDB needs to know these things to talk to your
Hitachi SH, H8/300, or H8/500:
-
that you want to use `target hms', the remote debugging interface
for Hitachi microprocessors, or `target e7000', the in-circuit
emulator for the Hitachi SH and the Hitachi 300H. (`target hms' is
the default when GDB is configured specifically for the Hitachi SH,
H8/300, or H8/500.)
-
what serial device connects your host to your Hitachi board (the first
serial device available on your host is the default).
-
what speed to use over the serial device.
Go to the first, previous, next, last section, table of contents.