Raduse Interactive Commands

The following commands are understood when raduse is in interactive mode. Some commands require an argument. Such commands are followed by the word arg. When raduse gets such command it displays a prompt and waits for user to enter the necessary data.

After processing each command the screen is updated immediately, no matter was the command understood or not.

RET

Refresh the screen immediately

SPC

Refresh the screen immediately

C-l

Clear and redraw the display.

^

(Caret) go to the first page.

b

Toggle brief display mode.

C-b

Move one page backwards.

C-f

Move one page forwards.

i

Toggle idle line display on or off.

j

Move one line forwards.

k

Move one line backwards.

G

$

Move to the last page.

q

Quit the program

s arg

Change the number of seconds to delay between screen updates.

t arg

Display lines on a given Network Access Servers. The user is prompted to input the NAS names. The names should be separated by whitespace. The word `all' returns to display of all NAS lines.

Go to the first, previous, next, last section, table of contents.