| Users: | LR |
| Hints: | -R |
| Huntgroups: | LR |
| Additivity: | Replace |
| Proxy propagated: | No |
This Attribute indicates the address to be configured for the user. It may be used in Access-Accept packets. It may be used in an Access-Request packet as a hint by the NAS to the server that it would prefer that address, but the server is not required to honor the hint.
The value 0xFFFFFFFF (255.255.255.255) indicates that the NAS should
allow the user to select an address. The value 0xFFFFFFFE (255.255.255.254)
indicates that the NAS should select an address for the user (e.g. assigned
from a pool of addresses kept by the NAS). Other valid values indicate
that the NAS should use that value as the user's IP address.
When used in a RHS, the value of this attribute can optionally be followed by a plus sign. This usage means that the value of NAS-Port-Id must be added to this IP address before replying. For example
Framed-IP-Address = 10.10.0.1+
Also section Add-Port-To-IP-Address.
Go to the first, previous, next, last section, table of contents.